Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
HART
I use transformer EMIT1200 or SM-LP5001 plus capacitor 0.47 uF - connect parallel of HART-line wires. For uncharge meet the resistor (100 kOm) after capacitor.
Crystal type must be choise by DataSheet of microcontroller. Capacitors must be set as crystal recommend. Oscillator may be run if capacity wrong but not haved a stability of frequency.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.