Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for your help.
I don't quite understand why they put two resistors in this circuit in paralell in the first place.
i just de soldered the 100 ohm resistor and managed to put the circuit on 22 volts where the total current draw 40ma (that should be the max. right?)
with 4 LED's in two...
Hi Guys,
this should be an easy one but i can't seem to figure it out:
I've got these LED trailer lights that i bought from China (there's the problem ;-) that were described as 12v/24v compatible but after testing then on my regulated power supply on 24V they didn't last very long:
It's a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
