Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
pic pwm decoding
Yes , i have access to the reciever.
The transmitters have two buttons . the first arms the car alarm , the second activates a panic alarm when the alarm is disabled . The alarm has a LED "ARMED" output so I wired a SSR to that and I use it to remote turn on some lights in my...
remote control+pic+pwm
Hi bunalmis, :lol:
The transmitters that I have use a PIC and definatley you PWM as an out put .
They transmit a 25bit signal (3 * 8bit + a "0" at the start for preamble)
A "0" is 300uS high then 600uS low , a "1" is 600uS high then 300uS low.
I was going to sample...
Hi ,
Does anybody have any code written in C to decode the PWM output of a RF remote control (from a car alarm) . Doesn't have to be code hopping just read the code so that I can display it .
Thanks in advance
Schmitt
:lol: :lol: :lol:
Mr Cool,
Your chip is a definatly a 4MHz version , the -04 at the end tells you that . If you had a 20MHz version it would be -20 etc.
What type of breadboard are you using ?
Is it the solder type (eg vero board or strip board ) or is it the plastic breadboard type where you plug components...
Mr Cool ,
Forget about the software its sounds like a hardware issue. I had exactley the same problem when I first started using PICs ! The Crystal needs 2 capacitors tied to ground to work correctly. I normally use 30pF but 27pF will do .
The problem I had was due to me using strip board (or...
beginning fpga hobby
I have managed to get a handfull of Altera EPM7064 devices . Does anybody have any nice projects I can use them for ??
Thanks
Schmitt :lol: :lol:
fpga hobby electronics
Jayson :lol:
BGA's are placed using high precision pick and place equipment that typically uses a video system to align the PCB . The PCB will have solder paste stenciled onto the board and this holds the device in place as it goes through a reflow oven . The ovens...
Does anybody know where I can buy a cheap PICDEM.net board in the UK ?
The £250+ price from Microchip is a little bit high for me !
Thanks
Schmitt
:? :?
arivv.org.
:lol:
Hi Guys,
Anybody got a schematic for a 2.4GHz video transmitter / reciever. I need to transmit over a range of about a mile !!
Thx's for any info
Schmitt
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.