Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The signal comes from the matlab, but it is a open loop ref signal, because due to my limited knowledge in control i wasn't able to design such controller. The open loop ref signal frm matlab is output from dSPACE and using a comparator circuit, i used a triangular carrier signal of 7 - 12khz...
no i am using the International Rectifier IR2111, it is somewhat similar to what you have intro me just now for IR2183/IR2184. Just want to ask another question, because i am working on a single phase shunt active filter, can the IR21844/IR21834 withstand high power switching for the IGBT? Any...
Is there any other way to increase the dead time to 1.5 to 2 microseconds. Currently i am using the IR2111 with 500ns time delay, but i am also unable to get to 500ns, i am also unsure y is it so?
Good Day Everyone,
May i check with you all, anyone knows how to design a dead time control circuit that can be used to provide two square wave signals to the half bridge IGBT inverter. It is the best that the two signals can have a dead time of 1.5 - 2 micro seconds. Please kindly assist...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
