Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
According to the SIMCOM Technical Support:
1) Command AT+CMUXSRVPORT is used to make physical UART interface for few virtual ports after AT+CMUX=1 enabled. And for host, there should be some special driver for linux/window OS.
2) Command AT+CGPSSWITCH is used to switch NMEA sentence output...
Hi,
I have a similar problem as the thread https://www.edaboard.com/threads/215743/.
I develop upon SIM5360-EVB_V1.03 and communicate through the UART (RS232) and UART2 (micro USB) to configure SIM5360. I want to develop a specific board with this chip and using only UART (RS232) as serial...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
