Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
ups schematic neede
here is a link for 500W inverter circuit.
https://www.electronics-lab.com/projects/power/033
Added after 49 seconds:
books r avalable in market
resistors
It is most probably because your multimeter just is not designed for measuring such high resistances.
You need specialised meters and setup to measure such high resistances
Check the specs of your meter.
npn pnp transistorer
A Bipolar Transistor essentially consists of a pair of PN Junction Diodes that are joined back-to-back. This forms a sort of a sandwich where one kind of semiconductor is placed in between two others
in tanner S EDIT tool ,after placing the component, i m facing problem in movement of the components. hoe to move or rescale the component. i tried a lot . spent 3 hrs to know. if anyboady know abt this plz reply me.
replace all visually detectable burned components, the open or shorted rectifiers, capacitors and resistors .observe the power supply section and disconnect the amplifier section from the power.
could u plz suggest about the acid and water to be filled in Inverter battery. once b'coz of over flow, battery had lost the required amount of acid . now i'd like to refill the propertionate acid and distilled water.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
