Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello to everybody,
I have a stupid problem with the ADS Momentum. When I use the Post-Processing tool to see the Radiation Pattern in 3D mode, I can see the Gain and the Directivity of my antenna, BUT both are in dB (not dBi or dBd, just dB). In my case the Directivity is 3.21dB and the Gain...
Thanks mate, I will give it a look :)
Thanks again :)
EDIT: So instead of using the VIA component, you just set a new layer and you define it on the substrate dialogue as via via? Clever :)
Hello again. What do you mean about the feeding point? The paper has it at the point that the narrow and the width section are connected. Or not?
I think that I found what it was going wrong with the vias. If I select for the HoleLayer = "hole" from the list, its seems ok!
About the substrate...
Thank you for your reply.
1) If I remove the ground and the second freespace layer, how am I suppose to define the two metal layers? (cond2-top and cond-bottom)
2) So at the HoleLayer="I will put the substrate?"
3) I have already use differential port :)
I will try them when I will be back...
Hello there. I am trying to design on ADS the antenna mentioned on the title. I am having some problems though. Ah, I forgot to mention that I am trying to design the antenna that is mentioned at https://ieeexplore.ieee.org/iel5/8/29739/01353517.pdf.
My problems are the following:
(a) I am...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.