Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi tahmid,
i have a doubt, what is the advantage of gate driver IC IR 2110 compare to optocoupler. because IR 2110 not providing isolation between the micro controller and power circuit then why we use IR 2110
Hi ,
i am using ir2110 as a gate driving circuit for single phase full bridge inverter. Microcontroller gives input to ir2110. does ir2110 provide isolation between power circuit and controller. still i am using common ground between the two, i didnot found anything wrong. if isolation needed...
Hi,
i need urgent help, now i am doing full bridge inverter with IR 2110 . to isolate the ground between +5v and 230v i want to use opto coupler can any one suggest what type of opto coupler to use,because microcontroller not driving the opto coupler
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.