Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Converting "CadStar gerber files" to "Pro
Thank you very much! It works perfect!
I havn't wanted to lose a time reading the *.pdf's and wanted to start the work quickly. I have read all the concerned *.pdf's now and all aspects are much more clear.
Thanks again!
Do anybody know how is most easy to build a "Protel2004DXP PCB" from "CadStar gerber set files"? I have tried with the Protel CAMtastic, but I have two major problems - aligning the layer is too difficult for me and finally I don't see the command "Export to PCB" active when I'm ready to export...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.