Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi every one...i simulated a mixer in ADS and now i wanna to simulate it by cadence,
I used some DC-blocks and DC-feeds in my simulation.how i can replace them in cadence???
Hi dear friends...
one question...in my simulation for linearization an active mixer, The conversion gain is reduced but the noise figure dose not decrease,it is possible? what is the reason? could u help me?
Thanx for your attention...
I used 3 baluns for (LO,RF,IF)
But I have a problem for simulate ... in display window the result has a lot of distortion for fundamental and 3-order Vif.
- - - Updated - - -
Thank you so much...It is a gilbert cell mixrer...I used 3 balun for LO,RF and IF...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.