Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you for the response Dave,
It does help me get a better understanding of receiver sensitivity and how it applies.
I think I have discovered how this -193 dBm/Hz makes sense when converting -130dBm on a 2.046MHz channel, what's added on, but not implied, is that there's a coding gain that...
Hi Frank,
Thank you for the reply. Just so I am understanding correctly Noise Factor would be the input sensitivity (-83 dBm) into account of IF bandwidth (in this case 450KHz, so thus the noise factor would be -83 - 10*LOG10(450e3)?
Am I to assume then that receiver sensitivity is normally...
Greetings,
I am attempting to do some RF analysis for interference and was curious how I apply receiver sensitivity.
I have a receiver that was given a minimum sensitivity of -83 dBm and the typical IF channel bandwidth is 450KHz. In this scenario, what does -83 dBm represent? Normally when...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
