Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
we have been told to use ADC's , DCM's and DAC's in project ..
i dont know how to go about the implementation of these ...
Added after 1 hours 35 minutes:
till nw i have written a code in vhdl to check how much frequency i get across the adc ... like me using 160Mhz n getting 80Mhz at the...
to synchronize and interleave two ADC outputs (under the constraints listed below) to achieve a combined sampling frequency of 160MHz. You will then design a band-pass filter circuit (with a narrow passband) to process your interleaved signal. The processed signal will be sent through the DAC...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
