Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by salman83

  1. S

    Small Data Packet Compression

    Hi, Thanks for the reply. Yes, it needs to be lossless compression. Also, the data is byte array.
  2. S

    Small Data Packet Compression

    Hi, I am reading some data on microcontroller which i want to send out to pc using usb. I need to compress the data so that i can send as much data as possible on usb. One data packet size is 16 bytes which I need to compress to 12 bytes as max. Does anybody know any algorithm which compresses...
  3. S

    Converting A/D value to float

    For example, I will take the first A/D value in the attached text file which is 5478960 So, 5478960 / 2^24 = 0.32657146453857421875 This is wrong, the above value is referenced for 200 degree centigrade. I need to map that value around 200 deg C
  4. S

    Converting A/D value to float

    Hi, I am reading the teamperature sensor values using ADS1278 converter. I do not know how to convert the A/D value into float. Remember that A/D converter is 24 bit. Also, I am attaching a text file which contains some logged points. Any help will be highly appreciated. Regards.
  5. S

    Microcontrolle Memory Management

    Hi, I have a coldfire MCF52254 microcontroller which is connected to A/D converter ADS1278 via QSPI module. I have configure the QSPI baud rate to 20 MHz. I am sending out the data via USB isochronous endpoint (interval = 16 ms) to the PC. My question is that i need to collect all the data...
  6. S

    Calculating torque values at low stains

    how to calculate torque from strain Hi Everyone, For past couple of weeks, I ran into a problem of getting a torque value at low strains. Actually, what I am doing is that I am applying a pressure or force on thick elastic compound while rotating the lower die to and forth using high precision...
  7. S

    Looking for the PCI v3.3 specification

    Hi, Does anyone have PCI specification v3.3. I just went to pci sig website but it is not free. So it will be grateful if anyone could share it. Thank you.
See more

Part and Inventory Search

Back
Top