Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
What does followpin option do edit wire in Innovus
Hi All,
I am relatively new in to PD domain. Can someone please explain what is followpin in routing.
In innovus, in edit-wire form, we can choose to enable/disable followpin. what is the impact if followpin is disabled?
Thanks in advance...
Hi,
you are getting setup hold conflicting path because the end point in violation has two paths coming to the same end point - one with large path delay and the other with less path-delay passing through a common logic before ending into end-point. You need to trace the path upwards and find...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.