Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I want to use the analog comparator of PIC12F675 in '100' mode,that is with internal voltage reference for Vin+ .Now my question is,to use Gp1 pin as analog input for Vin- ,do I need to do anything with ANSEL register?My program clears the ANSEL register in the beginning of the program and I...
Hi all,
I am a beginner to the works on antenna.I need to design an array of 8 patches.I want to implement it by corporate feed network structure,but dint get very good material on it.I designed 1 network on my own,can you please tell me whether the structure is ok or not?the microstrip line...
Hi,
I am very new to HFSS and not very knowledgeable about Microstrip patch antennas.I want to design a corporate feed microstrip array of 8 elements.I have got the dimensions of the patch but dont know how to find the input impedance of each patch and its connecting transmission line's.Also as...
Hi,
I have built a simple on/off switch with IR obstacle detector and pic12f675.The switch program was done to make it immune from Sunlight.What i did in program is that,the ir led will be on in general.when a hand ll come near it,it will drop the voltage at the ir detector led,which is pulled...
I have configured my 12f675's comparator module as '100' in CMCON(using internal reference and providing input at CIN-/GP1 pin.My question is that,shall I be able to use GP0 as input/output pin while operating comparator module in this mode as because of using internal volatge reference the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
