Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am using TI's LM2902 in unity gain buffer configuration. VCC is 12V and VEE is gnd, Non-inverting input is floating.when i measure voltage on non-inverting using DMM its showing around 1mv,but output of op amp is around 10V.
Why my op-amp is saturating?Output should be zero when noninvering...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.