Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
the resistve load is a pure resistance load such as resistor, whreras inductive load such as ideal coils , and capacitve load is like ideal capacitors ( the difference between capactive and inductive load one makes the current lead the voltage and the other is the opposite)
the usage of by pass capacitor is to block the DC conponent of the input signal.
the capacitor is model as short circuit because the capcitor allow the AC to move through it.
Re: Resistors Confusion
the difference is that the 1/2 w resistor can stand more power ( current) that the other one. usually the 1/2w is greater in size. Acually, which one you should choose depend on you aplication, some need high current and others need less.
Re: BASIC
the average valure is the DC component in the AC signal, whereas the RMS is the effective value that would generate a heat through a resistor like DC.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
