Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
probably this happens with imported model, where in the port sees the same conductor on both sides.
In other words there may be two conductors on the same layer across which port is connected(eg, ground and signal)
If this is the case the conductor has to be separated.
i AM TRYING to do parametric analysis for RF MEMS CAPACITVE SHUNTswitches IN HFSS.
I wanted to simulate for s parameters for various values of widths of the beam and various values of height of the beam (airgap)
The design variables are width and height. How can i assign these variables to the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.