Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
sir i am new in pic programming i want measure a peak volt value by pic 16f72 adc with 20 mhz crystel without zero crossing interrupt
full bridge rectifier with 100hz. 104pf peak hold cap in circuit
adc volt 2 to 4 volt
i have some questions
1.how to set adc hi-speed for it.
2.how much sample...
sir please convert this code in hi-tech c 9.80
unsigned char ch;
unsigned int adc_rd0;
unsigned int temp0=0,temp1=0;
unsigned max_point0 = 0;
unsigned int i,tlong0,tlong1;
// LCD module connections
sbit LCD_RS at RB7_bit;
sbit LCD_EN at RB6_bit;
sbit LCD_D4 at RB5_bit;
sbit LCD_D5 at RB4_bit...
thank you sir for reply...how i can measure these volts whithout and hardware modification ?
i need only measure volt. pulse is not nessasary for me.i need volts for main low cut off for my inverter project
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
