Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you for response.
I am wondering even in lower load resistor around 1kohm this current source does not work.
Do I need to change the opamp,? Is there specific opamps IC work better than others?
Do I need to change Resistors design ?
Thanks
Hello everyone
I want to have a VCCS. I used the Howland current source design.
I need to control load current by adjusting input AC voltage. I need a constant current in the frequency of the input. The current 1mA.
Based on the theory, I set the R2=R4=1Kohm and R1=R3=2Kohm. The load is in the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.