Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello
i try to read ADC at pin AN0 from a potentiometer and display the digital measurement.the max output voltage of the potentiometer is 5V and to get the digital measurement=vin/5x1023...but then at my lcd show measurement 255 instead 1023. from datasheet, the pic is 10 bit. please explain...
hello
i use MB1010 ultrasonic sensor for distance measurement. I put an object 1 inch in front the sensor and observe the voltage at AN0 of the pic pin and display the value on LCD. at that point i should get 9.8mV but then, i got unstable value.... anybody knows why this is happen
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.