Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
There is a paragraph in Pozar's 'Microwave engineering(318, 2nd)': "Since frequency resolution is determined by the Q of the resonator, the TE011 mode is often used for frequency meters because its Q is much higher than the Q of the dominant circular cavity mode. This is also the reason for a...
integration line for multiple modes
In common sense, I think there is no need to assign the integration line for waveports. In this case, HFSS can decide itself.
Yes, it do help. It's too hard to implement a very thin gap to realize an appropriate capacity, so I used lumped capacity, but the obtained result is still not very close to those have been present. Really thanks for help from all of you. It's the best place I have found to discuss and learning.
@purushottam
I need to load the antenna with "Wu-king" profile, that is to load the antenna at an equal intervals such that the resistance per unit length varies as a particular funtion of the position along the antenna. I want to not only load it at the port.
@adel_48
I tried it, but a problem...
capacity loaded dipoles
Hello,everyone, How to simulate a resistively loaded or capacitively loaded dipole in CST MW v5.0? Never see an example till now.
Added after 1 hours 16 minutes:
Anyone help?Thanks!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
