Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you PlanarMetamaterials for your reply.
[Err on the side of increased distance.]
can you please explain more?
I have to frequencies : 0.9 GHz and 1.8 Ghz "dual band stop passive FSS filter , the sweep is from 0.5 to 2.2 GHz I put Solution Frequency to 1.8GHz is this is best and close...
Using HFSS for*simulating of FSS dual bandstop filter (0.9 and 1.8 GHz), a Floquet-Port needs to be assigned at an appropriate height over the surface. How much is that height supposed to be? and how can I be so sure of the results if any small change in this height dramatically changes the...
Thank you kthackst for your reply, but when i right click overlays then plot field then there options E or H or J or other, if i go with E there will be three options Mag_E or ComplexMag_E or Vector_E.
so which one to chose and how to see fields distribution at certain frequency?
Thank you Nour, this tutorial is on HFSS software not Ansoft Designer, but thank you for your reply that was encouraging,
I hope I will find a tutorial of designing FSS using Ansoft Designer not HFSS
best regards
HI
I am wondering why there are no tutorials explaining how to design Frequency selective surfaces FSS using Asnoft Designer.
If You know such tutorial Please put here.
Thanks in advance for any help.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
