Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi All,
I am currently doing PBC layout design for FOUR button Capsense Controller for CY8CMBR2044 cypress.
I want to know which type of button is this ?
Is it Through hole or SMD?
can you please share me footprint for this button?
It is very urgent for me.
please give Reply.
Thanks in...
Hi,
What is High speed PCB Design?
What is RF Design and Mixed signal Design?
What is the parameters of High Speed PCB Design?
What should be take care during High Speed PCB Design?
Hi,
I am using allegro 16.6 for layout and i want to create .emn and .emp file for 3D view.
so is it generate from allegro or using other tool?
if generate from allegro then what are points(steps) to be follow one by one?
Thanks
Hi all,
I have allegro physical viewer and i want to cross probing between allegro viewer and schematic.
so please suggest me that how can i do this things?
Thanks
hi
yes , you are right.
so from where i can get this information?
please let me know if you know that.
please visit below link for sensor AR2500.
**broken link removed**
Thanks
hi,
anyone know that how many output voltages and current required on (Rx+,RX-,Tx+& Tx- pins)for AR2500 sensor ?
its datasheet shows only its operating voltages.
Thanks
hi,
I am designing smart sensor with i2c, UART and SPI interface and current & voltage measurement.
so which extra circuit is add for current and voltage measurement.
i am using ADC interface for current and voltage measurement.
i am using Load cell one of sensor..so how can it interface...
Hi,
Thanks for reply,
if i use same components value for 433Mhz transmission freq then how can i get 436Mhz transmission freq?
and we need pcb antenna for 436Mhz so please suggest for it.
Hi all,
I am working on RF design and use CC115l IC for 433Mhz 50 ohm. now i want to get 436Mhz with same IC , so what necessary changes are required? like component value change, or add more components etc.
please give reply as soon as possible.
Thanks
Hi friends,
if i used silicon Si7006-A20 sensor, NHD-C0216CiZ-FSW-FBW-3V3 character LCD with I2C interface and CAT24M01-D-91485 EEPROM , so which microcontroller is suitable for me?
please suggest microcontroller for fulfill uper requirements.
Thanks
hi,
Thanks for reply.
Right now there is no specific budget provide for it.
but , i am in learning stage so please suggest me which microcontroller is used for humidity measurement. can you please give some suggestion and which parameters are used for select it?
Thanks
- - - Updated - - -...
Hi ,
I want to make Relative humidity and temperature measurement with alarm system project.
so please give me guide to how to choose right sensors and microcontroller for it.
I need low power components because project is low voltage based(1.5 to 3.5VDC), not need high power.
I find some...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.