Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yes, normally if I change a variable the model updates the specific dimension immediately. Now in this particular one nothing happens at all. The numbers still change and save in the properties window but are not properly changed in the model.
I'm not sure if this is a bug or something I inadvertently did, but in the model I'm currently working on, none of the design properties (variable dimensions) are updating properly. They were all working fine and then suddenly...not. I tried the original model I was working from and it updates...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
