Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I need to find a fabricator somewhere around the Washington DC area that can build a gain horn transitioning from a WR975 to a circle. The circle will be going into the oven. Would it be better to have the circle bigger than the WR975 or make it fit inside? I would like to lose as little...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
