Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
'Vias' - that sounds like what I was thinking. Essentially a hole straight-thru with plates on both sides of the board that bridges the top side and the bottom side. Thanks for the reply all!
I could use a little layout advice. I'm developing a custom LED display PCB using Fritzing. Lots of LED's with resistors, etc. The board will eventually be mounted in a case with a light-diffusing layer over the diodes themselves.
A separate PCB, which drives the board, provides two 10-pin...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
