Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Sorry, I am a relative EE newbie and absolute EDA Board newbie.
So, the code runs but it outputs "14" continuously. I applied a varying amount of weight to the Load cell and received no change. I swapped out the INA126P, the load cell, the gain resistor, reversed the polarity of the load cell...
I am trying so set up a 4 wire load cell to measure weight. I have it connected to a INA126P in amp and that is connected to the Arduino Uno. I am not detecting any response when I apply weight to the load cell, and I don't know what is going on. If anyone can help, I would greatly appreciate...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
