Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, im wiring my old alarm kit, but im missing parts of the manual, like where i
wire the sensors.
I have wired everything but the sensors,the protection loop.
And there is a link between output 5-6, this was wired with a small cable.
If anyone is familiar with link,protectionloop or sensors...
Ok, this is what i discovered. from my expertice ive got 4 points to solve this.
+\- capasitor, and +\- in the starter circuit.
If i have to make a resolder of the winding part it is just one possibility, did not test if this is + or -.
First of thanks for answering my thread.
yes you say starter and winding circuit,
my idea for a start is to first solder the condensator of the circuit and then try to apply reverse current.
Im not familar working with condensators and think they wont work as expected if their applied wrong...
Hi,
I want to change the direction of this engine of mine
My supplyer tells me i Just have to switch about the +\-, but my investigation tells me otherwhise.
There is a condensator ontop of the engine. one i think 220uf or 2200uf.
Am i right is these about to blow if the current is wrong...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
