Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi davoud
actually my aim is when i will going to housed 6pin frc socket in my cable tester at that time i have check that 6 holes of frc sockets are empty or not i.e wires inserted on not
hi
i am looking for plastic detection sensor .i am working with harness tester project.
can any tell me for which sensor i can use for plastic detection ..
can any body explain me what is role of master/slave/slave loop role in hc05 .
bcz when i was use hc 05as master role that could not find by othe BT device .
and can slave mode send data from uc to pc?
plz help me i cant uderstand..
i want do pcb design for HC05 module with rs232 circuit .it can possible using protues7.6?
i have this bluetooth module https://www.rhydolabz.com/index.php?main_page=product_info&products_id=1169.
hi jay
i want send and recive rs232 data via bluetooth and also trap that bluetooth activity suppose bluetooth is sending data then it may be sow on lcd like "BT is in RX mode"
can uderstand my aim?
- - - Updated - - -
hi jay
i want send and recive rs232 data via bluetooth and also trap that...
hi jay
i am trying with this code plz check is is this correct or not .and i still using your ptotues file and i assume that that virtual terminal work as bluetooth module ..
- - - Updated - - -
hi jay
i am trying with this code plz check is is this correct or not .and i still using your...
thanks paul
i have already done that part i was interface 232max with 89c51 and right now i have connect that jy mcu bluetooth module with that 89c51.
and that 89c51 is also connected with 16x2 LCD .and my aim is i want recive /transmitt data serially via jy mcu then it should be deliaver at...
yes you are right it's limit up to 4.2 volt.but jay i can't uderstand where to i have star to do my object.what should be 1'st stap for interfaceing bluetooth with 89c51/lcd?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
