Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I design a velocity control with DC brush motor, constant magnet and PID controller
The velocity I measure with Hall Effect sensor
My problem is that I don't have the motor parameters to build transmission function with the PID controller
Anyone know how I can receive transmission function with...
I search after communication unit
The range between the 2 computers need to be approximate 10 meter
I will glad to read suggestions for communities units and what is the preferable unit
I design a system with micro controller PIC 16F88
The micro controller need to control the velocity of the motor because of this I use PWM output and Hall Effect sensor that transmit pulses
The system is use close loop control
My problem is that I don't succeed to use the micro controller for...
Does this oscillator is suitable to use with low frequency
I build a oscillator with 5 [MHz]
I want to work with 7 volt and 10 mili amper
who i can calculate the right value of the components ?
But I want to use the coil with low value, How to do it ?
What are the different between different...
Need info about oscillator and sensor
I build a 5 [MHz] oscillator
This is for a belt coil sensor that change the induction
This electronic circuit also has a battery
The output is sinus voltage
I need to calculate the right value of the oscilator component
I search after the name of this...
Re: convert the signal 1
Sorry, I want that the system (The 4 motors) will controlled by a remote control
I want that the micro controller will convert the FM signal from the transmitter to PWM within 2 [msec]
I planning to build a system with 4 brushed motors, drivers, micro controller, transmitter and receiver
I search methods to convert the signal in the micro controller that will change the velocity within 1.5 [msec] ~ 2 [msec]
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.