Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, sorry for the late reply, no the ic has no id numbers on it?
Would you know where i could get a similar board for it within the uk.
I'm at odds with this now.
Or can i somehow wire it so it goes from power to switch then to motor and place on a timer socket in the mains?
Regards...
Hi, thanks again for your input.
I am not sure what value i would be looking for if i checked with a multimeter and how would i check if they were bad?
The ic is, i believe, to tell the motor to torn for several minutes and then turn the opposite way, and a few other rotations dependant on...
Hi, thank you for your reply.
I have checked the motor and this apoears to be working ok when connected to a power source, and thank you for the info but they are just on the track of motor or belt drive problem?
Regards rob.
Hi Hi all, first of all, this is my first post, if in te wrong place, I'm sorry.
I have a excelvan watch winder which does not work. I will show pictures of the circuit board, i have changed the capacitor but to no avail.
I have tested the board with a multimeter and tere appears to be...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
