Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
crosscoupled VCO in keysight ADS
Hi. I am designing a cross-soupled VCO in ADS. The circuit diagram using the small signal model of transistor is as follows. While performing the transient simulation, I am not getting the oscillating waveform. Can Anyone please help me out with the issue...
Hi. I have used a small signal model instead of actual transistor just to check whether I am getting an oscillating waveform in trnsient response. But I am getting the results as follows. Can anyone please help me regarding the issue.
[Found at imgur. com /a /18smyoP]
Hi. thankyou for your reply. Could you please tell me how to excite the circuit temporarily and also there is no relevant example on cross-coupled VCO in ADS. If possible can be please provide me with the details. Thanks in advance.
Hello,
I am currently working on designing a low-power consumption and low phase noise cross-coupled VCO in keysight ADS. I am not getting the transient response i.e the oscillating waveform for my circuit. Could anyone please guide me through the process. I am hereby attaching my design...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.