Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I'm embedding the step file into both a pcb and a fooprint library. it's doesn't show up on the layer.
but,
yesterday, i'm trying (trial and error) to solve it and succeed. my fault lies in input "Standoff height" = 0 mm (3D Body Window). then i'm trying to change it to 1 mm. the result, my...
when I enter the 3D Step Model to my pcb library, the model does not appear....
i have go to Place > 3D Body, i'm choice Generic Step Model, then i'm hit Ambed Step Model, and i have chose my Step File, but when i'm click OK Button, the Model isn't Appear / Show in my PCB doc/ Library.....
Can...
i have watching this video (https://www.youtube.com/watch?v=05imB2OFlVI) , but this video don't tell me about programming device (AT89C51). can someone tell me about the step for make its hex file on keil uvision (4) ? :smile:
this is its code :
#include<reg51.h>...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.