Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Depending on resin type, boiling hot water might suffice. Or placing in a oven, up to about 130ish centigrade should soften the resins. Possibly the bobin might not survive though.
Reusing old ferrites might be tricky if you are planning to go high in frequency.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
