Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
ir2110 problem
Thank you,
What sort of boot diode should be used?
byv27 or byw28 is ok for 200V mosfet DC bus?
Is it possible to drive the IR 2110 with 1us pulse width?
Thank you for your time.
Hi,
I've setup the following circuit to test ir2110 mosfet driver
But I couldn't get any voltage on the scope screen even input of the 2110 toggled via mechanic on/off switch.
Any advice?
Thanks for helps.
Hi,
As you see in schematic there is 2 supply and 1 gnd. How can I switch them with mosfets. What mosfet config should be. Could you please show a circuit.
Switching time will be 1 microsecond.
Mosfets will be switch by microcontroller and has done.
Thank you so much for any help.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.