Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by Rhul

  1. R

    MCT 2E base pin no connected

    I got the solution ...i have connected 6 th pin of MCT2E to the ground with 4 mega ohm resitance..now it tis not floating..
  2. R

    MCT 2E base pin no connected

    Yes voltage is sufficient..relay chatters when it is off..
  3. R

    MCT 2E base pin no connected

    Yes iam using transistor after mct2e to drive the relay relay is pcb mounted
  4. R

    MCT 2E base pin no connected

    Relay cnnected through mct2e chatters some time
  5. R

    MCT 2E base pin no connected

    Yes frnd m geting problem i checkd other part of circuit that part is ok,..mct2e 6th pin is the cause of problem
  6. R

    MCT 2E base pin no connected

    Unconctd pin act as antenna ..and pick some random noise
  7. R

    MCT 2E base pin no connected

    I checked it with c.r.o ..it shows floating voltage
  8. R

    MCT 2E base pin no connected

    I tried to ground the base with 10k,20k,50k and 100k..but this make mct2e off permanently
  9. R

    MCT 2E base pin no connected

    as this pin is floating so this pin is picking noise sometimes
  10. R

    MCT 2E base pin no connected

    Hiii Friends ..I want to know .....where to connect the 6 th pin of a optocoupler MCT2E ..as it i shown unconnected in the data sheet of MCT2E..thi pin is creating problem for me as it becomes floating..So plzz provide me the solution..
See more

Part and Inventory Search

Back
Top