Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have generated Pseudo Noise using a PIC 12c672 .Basically is having arrays . You can tap the array and exor it with a value. The sequence will repeat atfer some time, but looking it into an spectrum analizer it was enough for my purposes (apply this noise to a laser) .
Re: Simple FM reciever
Here some usefull projects you can build
h**p://www.oldradioworld.de/gollum/sloped.htm
h**p://www.zen22142.zen.co.uk/Circuits/rf/fmreceiver.htm
VCO measurement problem
VCO are sensitive to test probes. Usually when you use an oscilloscope probe or even coaxial , the VCO unlocks . If you are using an spectrum analyzer, the best way is use a FET probe too. This comercial probe is attached to the spectrum . Valid measurements can be...
Re: Phase Noise
Other noise source is the reference oscilator. Add a series 3 to pole Band PAss filter to your reference .
VCO noise ( if using comercial VCO) is inherent and not much can be done.
To get the lowest noise, usually the shunt capacitor( cap to ground) in the loop filter has...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.