Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am designing a SMPS with a PFC correction circuit and then a 390V to 24 V DC-DC converter. Both the PFC chip and the DC-DC converter chip require a 12v VCC. Any suggestions for a circuit? I was thinking of using a resistor and a cap with a clamp after the diode bridge, but it is about 30 mA...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
