Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
IC fails to respond to any comm via SPI bus. Signals into IC are good. Nothing ruled out at this point.
Do you know if the copper, soldermask, and paste pattern shown in original post is good?
-Dave
Klaus,
About 10% of the circuits built with a similar IC that this will replace have had a failure related to processor communication with the part. I've asked for x-ray analysis from the factory and buzzed out failed PCBAs, but no obvious answers yet.
-Dave
I would be grateful if some experienced designers could evaluate the attached proposed footprint design and provide any feedback. I've had trouble with similar packages in the past. Not sure if it was the footprint design, pcb fabricator, or the assembly house.
The footprint details I am...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.