Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Friends,
Good Day to you.
Am using Proteus 7.8. Recently i had a issue in a file which was on hold for a long time and the layout was also 70% finished . I received a latest file with many parts removed and new parts added in that schematic. after assigning the components imported Netlist to...
Hi All ,
I would like to ask, is it possible to do hand soldering in BGA??
is there any easy method to Solder it?
for a prototyping we can use SchmartBoard , but the quantity of the product is very less in count so we cant prefer an outsource here. and any one say how to hand solder BGA in...
Hi alexan_e ,
Thank you for your reply.
Am following the same order as u had mentioned.
Actually wt i do is i pull out the netlist in Schematic ISIS and ARES in two .xls files and do comparison .
As the net from the ISIS and ARES are correctly connected same net or not, pin count, any NC...
Hi All,
Once again i like to raise this question.
I am using ISIS for schematic design and ARES for PCB design,
I want to do final netlist cross check by taking out the netlist file from ISIS and ARES and comparing it.
But what the problem is both the files are in different...
Hi All,
Am using Proteus ARES-7.8 for PCB design. I want to give an oversize mask size for the component pad.
At present the Component Mask clearance is exact with the same size of the pad. But I would like to increase 20mil than the pad. Can anyone help me how to add extra clearance, by which...
Hi All,
I am using ISIS for schematic design and ARES for PCB design,
I want to do final netlist cross check by taking out the netlist file from ISIS and ARES and comparing it.
But what the problem is both the files are in different format and the netlist priority names are also found...
Re: How to do differential pair routing in ARES pcb design.
Ya Alex,
The same thing only..
I tried a lot to find some other way to route it.. but i am still searching on it.
So its not possible in ARES. Right?
Thanks in Advance,
REM
---------- Post added at 13:04 ---------- Previous post...
Hi All,
I am new to this membership. i am very glad to see the comments in this website.
I too have some doubts, kindly give comments.
I am using ARES PCB designer, when I try to route a differential pair there was no option I noticed.
Is it possible to do differential pair routing in ARES PCB...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
