Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Even on a two-layer PCB, a plane is useful for me for better conductivity on high-current nets. Also, when using chemical etchant I'll have to remove less copper. Anyway, how do I make a copper pour?
I've been reading the Altium Wiki to try and learn how to use the PCB tools. Currently I want to route a board with only two surface copper layers, one on the front and one on the back, and *no internal layers*. Is there a way to have a power plane on the surfaces of the board instead of adding...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.