Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I've designed a board with analog and digital signals where I've tried to isolate the analog section. I've read about the benefits of keeping analog and digital ground on the same plane. One question I have is should the analog ground be tied directly to the power supply ground, or have to go...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
