Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
This topic is discussed in Pressman's fine book "Switching Power Supply Design".
A converter can run in DCM or CCM with no change in feedback control. But as you point out, the two modes are different and the transisition from one to the other can cause stability problems.
Lets look at...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.