Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I'd like to make a via(only) keepout zone with ares6. Is it possible to do this ? When I use a keepout, it's a "global" zone where no routing is made...
Thanks you.
8 mhz instruction clock cycle
Hello,
Can someone tell me how fast is an instruction time for a 16f88 when using the internal oqscillator of 8MHz ?? Is this 1/8Mhz or 4/8Mhz ??
In fact when we use a 20MHz crytal, the instruction cyvle is 4/20MHz, is is the same for the internal 8MHz osc ...
iar z80
Hello,
I'm using IAR C Compileur for Z80 (I think it is ICCZ80) and I dont find how to set the adresses of my ROM and RAM. In my case, my ROM is between 0000h and 1FFFh ; and the RAM is between 8000h and 87FFh.
So I'd like that the compileur place the stack in the top of my ram (87FFh)...
proteus avr eeprom
Thank you for your information, this is ok now for me.
Before running a simulation with internal eeprom data (in serial eeprom, uc eeprom,...) isis need to "reset the internal data" with the command DEBUG>RESET PERSISTENT MODEL DATA. If it could help someone...
eeprom simulation in proteus
Hi,
I make a simulation of a avr at90s8515, the programm .hex is ok, this run fine... but ICCAVR create me a file X.eep that i cannot load from proteus...When the simulation run, data aren't the eeprom data( but FF).
I d'ont understand because there is no error...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.