Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I tried using a lower baud rate, but it didn't work. The garbled characters actually have an extra 1 on the 8th bit. For example, '\r' which has a value of 13 (1101 in binary) becomes the square shape character with the value 141 (10001101), while 'O' which has a value of 79 (1001111) becomes Ï...
Hello,
I'm writing a code in C++ to send AT commands to a GSM modem. According to the modem manual, these are the settings that should be entered in hyperterminal:
Bits per second: 115200
Data bits: 8
Parity: None
Stop bits: 1
Flow control: Hardware
In my code, these are the dcb settings for...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
