Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
For its primary function, I would refer to a flyback transformer as coupled inductors but not a power transformer. Power transformer is coupled inductors but inductance of the inductors is counter to functional objective of a power transformer.
Pretty narrow definition of DC current solely based on Fourier analysis.
Turning on a DC device changes current so DC device that draws current must not exist.
A DC to AC sinewave power inverter has a fullwave rectified sinewave battery current profile so it should be called an AC to AC...
This is an operating system function in conjunction with hardware. The 'standby' mode copies present operating setups and RAM to hard drive and puts hardware in a power down mode. When you touch the wakeup button it wakes up hardware that pulls the configurations and restores RAM to point...
Because USB-C can be plugged in either direction there must be mirrored connection duplication in the socket. USB-C jacks typically do not internally connect the mirroring in the actual USB-C jack, leaving it up to the PCB layout to make the common mirrored connections.
It is just physically easier way to get the alternating phase and required boom parallel impedance.
There are some TV antennas that use a single support boom with criss-crossed high impedance balanced wire pair transmission line to interconnecting the elements with plastic insulators to support...
The power and current specs for a MOSFET is based on infinite heat sinking. Current is also limited by wire bonds and package leads.
Heating of the MOSFET will be the limiting factor which depends on your physical heatsinking capability.
A MOSFET with lower Rds_ON will generate less heating...
A permanent magnet with a coil wrapped around it will have no voltage or current in coil. This is what you will have if you allow the residual magnetism to build up in transformer core by running imbalanced switching currents-seconds. This reduces the AC flux induced delta before core...
The picture you showed is not a charger. It is a charging port.
It is an AC outlet that communicates with EV so EV charger in vehicle does not pull too much AC current from the given charging port AC outlet.
The picture appears to show some charge level info reported to it by communications...
What you will see is utility control on PV power push. If power company begins to lose control on system they will remotely command GT inverters in an area to shut down or at least prevent grid power push.
Many low cost BMS's for LiIon battery arrays use simple low current bleed resistors for cell balancing. For high AH batteries, 100 to 200 mA of balancing does not do much more then keep up with leakage current variation between cells.
There are a couple of low cost boost switchers modules that...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
