Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I used two VCD files from a design to run PTPX to generate power reports.
One VCD file was obtained using netlist simulation without SDF annotation while the other one was with SDF.
PTPX was run in both averaged and time_based modes.
The reports were showing that the total internal power...
Hi, I have generated a few power reports from Synopsys PTPX using a netlist simulation vcd file.
I would like to get more information of how each figure in the reports being obtained.
Please share your ideas and suggestions. Thanks.
It is linked to the .synopsys_dc.setup file under Synopsys installatation directory, but it is a read only file.
Is there any way that i can edit it?
Thanks!
Dumping a vcd file starting from a "RST" transition to high until the end of simu
Hi, i am writing a tcl file to run simulation on ncsim.
i need to dump a vcd file starting from a "RST" transition to high until the end of simulation automatically.
please suggest a tcl script template to run...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.