Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for the reply. Yeah, if I could sense the current through the load that would definitely work, but I can't think of a good idea to do it. All loads are driven by DC. There is about ten loads and the current for each ranges from 50mA to 20A. Each load would be driven by an individual...
post load sense
I am doing a project for a module that controls the switching of a few different loads. A microcontroller will be controlling most likely a MOSFET to switch the current to the load. The module must be able to "sense" the load, in that the microcontroller must know if a a load...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
