Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
tetra mesh
Hello all,
Anyone have any idea why is that with the Stationary current solver i get different answers for the current going through a current port set at a specific voltage when i run th solver with a Hex mehs, and with a Tetra mesh? The answers should be the same right?
Thanks
capacitance at infinity
Hello,
So i was trying to calculate the capacitance between two parallel plates as an exercise. I noticed that it gave me an answer in negative farads. One plate was at 1V, and the other was at 0V (it didn't want to simulate unless I had sources assigned). Both plates...
I don't have a particular project (yet). I was just curious if there were particular rules of thumbs you could follow to let you know which programs might be more sufficient. I've used XFDTD in the past to do some antenna simulations, that's about it.
em boundary conditions
Hello,
I'm a little confused here.
So i know that setting your boundary to Electric is basically like putting a ground plane.
What is a magnetic boundary analogous to?
Also, i don't really understand why you would pick one boundary over the other in a particular...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
